BOM Data Receiver

This receiver is used by the Wethalert system being used around australia.
It uses 1200 BPS BELL modem tones. My intent is to add this data stream to
the APRS data stream in some correctly formated way
Correctly formatting should not be too much problem. The messages come through
with a lifetime on the message.

Rainfall Radar

Sydney
Australia
Lightning

Boltek
Strike sentence
$WIMLI,,,,*
ddd corrected strike distance, in miles.
uuu Uncorrected strike distance, in miles.
bbb.b Bearing to strike, 000.0 to 359.9 degrees
cs Checksum in hex
Noise sentence
$WIMLN*
Status sentence $WIMST,,,,,,,,
ccc Close strike rate, 0-999 per minute
sss Total strike rate, 0-999 per minute
ca Close alarm status, 0=not active 1=active
sa severe alarm status, same
hhh.h current heading from gps or compass 000.0 to 359.9
____
Welcome to our Techical Site. If you are interested in an overview, then visit our
Marketing Site
Copyright © 1994-2006
Radioactive Networks ,
darryl@radio-active.net.au
This page was last updated 2005-09-01 20:08:07
This page was last compiled 2006-02-21 14:50:54
Question or Comment? Click
here
|
|